AL Priority laser jammer

AL Priority support is experimental. Switch it on under Menu → Settings → More → Experimental → Antilaser priority (ALP) integration; the app asks you to acknowledge that features like active jammer state and JTK (Jam-to-Kill) may not work as intended yet.

What you get#

• Laser alerts on the signal card and the full-screen laser takeover, with the jammer's Defense or Detection mode.
• Stop jamming (switch to detection) on the takeover and the jammer page, and Mute current alarm.
• The jammer runs in parallel with your radar detector, so both alert.

Pair#

With the Experimental switch on, Menu → Detector → Devices shows a Jammers section. Tap Add Laser Jammer and enter the jammer's PIN when asked. The jammer page then shows its status, and the status strip gains a Laser jammer chip.

During a laser hit#

The screen turns red with the gun type when the detector identifies it. Tap Stop jamming to switch the jammer to detection. The jammer alarm is always spoken, whatever your notification profile.

Manage#

The jammer page has Disconnect, Forget jammer (you will need the PIN to pair again) and Factory reset, which erases the jammer's own settings.

Profiles#

Jammer mode is not part of detector profiles.